Filter
Top Products
4-3
Hardware Installation
4.1.2. Connect the MPC to Your Power Supply
Refer to the cautions listed below and at the beginning of this User's Guide, and then
connect the MPC unit to an appropriate power supply.
Note: Some MPC units are shipped with one or two detachable 125 VAC,
15 Amp "Starter" Cables. These cable(s) will allow you to connect a 120 VAC
MPC unit to power for bench testing and initial start up and are adequate
for applications that only require 15 Amps. For higher amp power switching
applications, please refer to the WTI Power Cable Guide (which can be found
on the CDROM included with the unit) or use appropriate cables.
CAUTIONS:
• Before attempting to install this unit, please review the warnings and
cautions listed at the front of the user’s guide.
• This device should only be operated with the type of power source
indicated on the instrument nameplate. If you are not sure of the type of
power service available, please contact your local power company.
• Reliable earthing (grounding) of this unit must be maintained. Particular
attention should be given to supply connections when connecting to
power strips, rather than directly to the branch circuit.
4.2. Connection to Switched Outlets
Connect the power cord from your switched device to one of the AC Outlets on the MPC
unit. Note that when power is applied to the MPC, the AC Outlets will be switched “ON”
by default.
Note that some MPC models feature two separate power branches, while others
may feature only one power branch. Please refer to the table shown in Section 1 or
Section 3.1 for more information regarding maximum power and load ratings for your
specific MPC model.