Xantrex Technology XDC 10-1200 Power Supply User Manual


 
GPIB Operation
TM-XDOP-01XN 4–21
SCPI
To set up GPIB control parameters:
SYST:COMM:GPIB:ADDR <GPIB-address>
where
the GPIB address may be in the range 1 to 30.
To configure the unit to generate a power-on service request:
SYST:COMM:GPIB:PONS {ON | OFF}
To select GPIB as the remote control source:
SYST:REM:SOUR GPIB
Using GPIB
Sending a GPIB command should put the power supply in remote mode with the
RMT annunciator lit.
Refer to the manual for your GPIB interface card. Commands to change remote
and local mode will be specific to that card.
Press the LCL/RMT button to return to local mode, except if the power supply is
in LLO (local lockout) state.
TM-XDOP-01XN.book Page 21 Monday, July 17, 2006 11:19 AM