Xantrex Technology XDC 10-1200 Power Supply User Manual


 
iv TM-XDOP-01XN
Organization
This Manual is organized into five chapters and 5 appendixes:
Chapter 1, “About The XDC Power Supply”, Chapter 1 lists the features of
the XDC and shows diagrams of the front and rear panel.
Chapter 2, “Installation” Chapter 2 explains how to mount and wire the XDC
and also how to perform basic functional tests.
Chapter 3, “Operation” Chapter 3 explains how to power on and power off the
power supply. It provides information about configuring the power supply, and
also gives procedures for operating the supply via the front panel controls and
menu functions.
Chapter 4, “Remote Operation” Chapter 4 provides an overview of how to
use remote analog control, gives information on the setup and use of Multichannel
functionality and explains how to send commands to the power supply using the
SCPI programming language
Chapter 5, “Current Sharing” Chapter 5 explains what current sharing is, and
shows how to configure and operate units in current sharing mode.
Appendix A, “Specifications and Characteristics” Appendix A lists all of the
electrical, environmental and mechanical specifications of the XDC.
Appendix B, “Calibration (6000 Watt only)” Appendix B lists the calibration
procedures for the 6000 W unit. If you purchased a 12000 Watt unit, please
contact your supplier or Xantrex directly (see “Warranty” for contact
information).
Appendix C, “SCPI Command Reference” Appendix C provides a summary
of the Standard Commands for Programmable Instruments (SCPI) that are
supported by the this Programmable Power Supply.
Appendix D, “Error Messages” Appendix D lists all the error codes and their
meanings.
Appendix E, “GPIB” Appendix E describes the General Purpose Interface Bus
(GPIB) commands and lines supported by this model.
“Warranty and Product Information” This section explains the warranty and
provides information on returning your unit for service.
TM-XDOP-01XN.book Page iv Monday, July 17, 2006 11:19 AM