Filter
Top Products
2750 op#2 R3.doc 10-02 Page 2-2
Operator’s controls
The push-buttons on the operator’s control panel are “soft-programmed”, which means they are used for
a number of tasks including selection of the fold program to be applied to incoming prints. The folder
firmware includes over 50 fold programs (“tables”), up to 20 of which may be quickly accessed by the
operator using the push-buttons. (The fold programs are listed in Chapter 4, and also in the Fold
Directory. A separate set of up to 20 programs for hand feeding is also provided.
In most cases the folder is connected to a host controller through its serial interface and when the folder
is powered up the display will read ONLINE. If the folder is not connected to a host or the
Communications mode is not
set to “Normal” the control panel displays the first four fold programs
selected for your folder, as in the example below:
1: 8.5 x 11 PORT C 8½” x 11” C-folded packet, portrait style
2: * 8.5 x 11 LAND C 8½” x 11” C-folded packet, landscape style
3: 9 x 12 PORT Z 9” x 12” Z-folded packet, portrait style
4: 8.5 x 11 BkaZ 8½” x 11” book-folded packet (Z fold only)
In this sample display, fold program #2 is active, which means the folder will fold every incoming print
(other than A-size sheets) into 8½” x 11” landscape packets.
If more than four fold programs have been selected for your installation, press the MORE button to
display.
Receiver Advance
Advances conveyor belts
on High Capacity Print
Receiver
,
if installed
Folder ON
Handfeed
Pressing the Handfeed push-
button switches the 2750 into
hand-folding mode, displaying a
modified list of programs. The
print to be folded is fed into the
rollers at the rear of the folder
(image face-down, title block
leading - centering is not
important, but alignment is).
Indicates a fault/jam
condition, or open cover
Operator's Control Panel
Synergix Fold System 40
Models 2753, 2755 and 2757
have similar control panels, with
plain language in place of icons,
e.g., MORE in place of +>