Filter
Top Products
2750 op#2 R3.doc 10-02 Page 2-6
HAND
FEED
HAND
FEED
HAND
FEED
HANDFEED light off
- hand feed program not initiated
HANDFEED light on
steady - folder is ready to accept a print
HANDFEED light flashes - folder is currently folding a print
To begin hand feeding ...
1. If applicable to your system, check the printer controller/host computer to make sure no prints are
queued to the folder.
2. Press the HANDFEED button. If a fold is in process or a sheet coming command has been set by the
controller an audible beep will sound and the HANDFEED button must be pressed again when the
system is clear. At this point the LED is a steady green and the folder is ready for hand feeding.
3. On the operator’s control panel, press the appropriate push-button to select the desired packet size
and style.
4. Slide the accessory plate back from the infeed slot.
5. Turn the document face down
, positioned so that the title block is nearest to the infeed slot.
6. Keeping the document square to the infeed rollers, slide it gently forward until the infeed sensor
energizes the drive system.
During the folding process, the HANDFEED green LED on the operator’s control panel flashes, indicating
that the system is busy. Do not try to hand feed another document until the light stops flashing.
Hand feeding a document
Center the document in the infeed slot, then
feed it slowly forward until engaged by the
rollers.