Filter
Top Products
2750 op#4 R3.doc 10-02
Page 4-4
To edit the operator’s program list, select
Assign Folds from the SYSTEM MENU. The control panel
displays:
Fold Menu: #2
Fold Table:
Number
Description
1: Change 4: Quit
NOTE: “Table” = Program number in the folder firmware, see Section 9.
The #2 menu selection is the first one available for editing because the first selection is always
STACK, which cannot be changed. To change or delete the selection press 1. The control panel
displays:
1: Set By Fold Table #
2: Choose from List
3: Remove from Menu
4: Quit
If you do not know the “table” (fold program), or do not have Section 9 available, press the 2
button to enter the list, then scroll through to select (press 1 to “Add”). To delete the current fold
program from the Fold Bank, press the 3 button (this does not
erase the program from the
firmware). Press 4 to return to the previous display.
The maximum number of fold programs that can be included in the operator’s program list
(NVRAM) is 20.
Recent errors
Displays the last 21 fault conditions, and the number of prints successfully passed between
events. Event #1 is the most recent. Example:
Event
# Error code Quantity
1. 0042 (occurred after) 1957 (prints passed since previous event)
2. 0010 4350
3. F142 5128
Activity counters
1. Mechanical counter
The mechanical (electromagnetic) counter situated below the power switch records
linear feet.
2. Software sheet counter
In addition to linear feet displayed by the mechanical counter, the folder also keeps
track in software of the number of sheets ("clicks") processed. This is displayed in
the Parameters menu as follows (two lines due to display limitations):
SHEETS (Ks) 1 4 8 7 = 1,487,000
SHEETS (1s) 3 0 5 305
Total 1,487,305