Filter
Top Products
2750 op#1 R3.doc 10-02 Page 1-4
Bridge
The bridge is the link between printer and folder. Its main functions are determining the media width on
which the incoming document was printed, and providing the means for measuring length of the
document. It also signals the in-feed system to accelerate once the document has left the printer, the
purpose of this being to increase the separation between one document and the next. This allows the
folder to accommodate high-speed printers with small inter-copy gaps.
Stacker/Handfeed
Pressing the Handfeed button on the control panel activates the off-line folding system, allowing prints to
be fed by hand across the top of the accordion folder into the rollers at the rear of the tower, diagram next
page. The tower also enables the flat-sheet bypass, or stacking function. This is selectable in the same
way as a fold program on the control panel (press the button indicated for Stack). In the bypass mode,
the stack diverter at the rear of the bridge is flipped down so that prints exiting the bridge flow through the
tower instead of the accordion folder.
Automatic document diversion
In the event of a paper jam or power failure,
a solenoid-actuated diverter at the input end
of the bridge swings to the upper position,
diverting documents to the floor,
Power-off condition
Power-on condition
Instant service access
There is no need to set aside extra space
for access to the printer. The bridge pivots
to the upright position, clearing almost 3’
(
90cm
)
between printer and folder.