Filter
Top Products
2750 op#2 R3.doc 10-02 Page 2-9
BRIDGE and BRIDGE EXIT
Raise the bridge lid.
1. If the document is visible ...
2. ... and has not entered the accordion folder, open the bridge lid by disengaging the catch in the
center of the forward rail, then pull the document clear in the normal direction of print flow. Close and
lock the bridge lid.
... and is partially within the accordion folder, open the bridge lid then pull the document back out of
the accordion folder. Close and lock the bridge lid. (If the folding process had begun before the jam
occurred, it may be necessary to clear the paper from the accordion folder, see “Accordion Fold”
below.)
3. If the document is not visible, close and lock the bridge lid
, then raise the bridge to the vertical
position.
Raising the bridge lid
Release the lid by rotating the center
catch counter clockwise.
Unlocking the bridge
A knurled knob on the right side of the tower,
adjacent to the operator’s control panel, holds
the bridge in the down position. Rotate the
knob clockwise two or three turns to release
the bridge, then gently raise the bridge as
shown.