Filter
Top Products
2750 op#4 R3.doc 10-02
Page 4-2
Passwords
Certain menu items displayed on the control panel are password protected for the KEY
OPERATORS and TECHNICIAN ONLY. Untrained persons adjusting parameters can cause a
great deal of damage to the folder. For each of these, the user will be prompted to enter the
password. Use the number
1 button (up) until the appropriate number is reached, then press the
number 3 button (set/enter). You now have access until either of two events occurs: Power to the
folder is cycled on/off; or, a 10 minute interval passes with the keypad in the operators fold
selection (default) mode. In either event, the keypad will return to a locked state requiring re-entry
of the password.
System Menu
Page 1
1: Communications mode
2: Infeed jog Fwd Jam clearance – drives infeed motor forward
3: Infeed Jog Rev Jam clearance – drives infeed motor in reverse
4: Parameters
Page 2
1: Device Test
2: Assign folds
3: Assign handfeeds
4: Recent errors
Page 3
1: Stack sensor
2: Quit
Communications mode
Page 1
1: NORMAL = Normal printer/folder communications
2: USE KEYPAD FOLDS = Overrides Controller fold selections, but maintains communications
(e.g., for job recovery)
3: NONE = Serial port disconnected (comms OFF)
4: LOOPBACK TEST = Communications test
Page 2
1: Quit
Jog functions
These are accessible to the operator - no password required.
Parameter viewing and modification
Viewing - unrestricted access
Modification - technician only
The Key Operator Password can be obtained from your service technician.
Substitutes for an LED. Displays the status of the photosensor at the tower exit: 1
= open (no paper present), 0 = covered (paper detected).