Filter
Top Products
PREINSTALLATION
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE 3-7
Space planning guidelines
This section describes the installations space requirements for the
DocuPrint 96/DocuPrint 96MX LPS that include the following:
• Clearance space
• Cable lengths
• Cable locations
• Efficiency of use
• Delivery access requirements.
Clearance space requirements
Your DocuPrint 96/DocuPrint 96MX LPS must be installed in a fixed
location and have:
• 36 inches/914 mm of clearance on all sides of each component,
including any finishers or feeders you have attached to your
DocuPrint 96/DocuPrint 96MX LPS. 50 inches/1270 mm
clearance is required at the front of the printer
• 78 inches/1981 mm of vertical clearance throughout the entire
area
• 24 inches/610 mm of exclusive operator area in front of each
component.
Shared space
It is always best to provide the full amount of clearance space around
your LPS. It is sometimes necessary, however, to have shared space
between components, such as between the printer and the system
controller, or between the DocuPrint 96/DocuPrint 96MX LPS and
another printing system. It is possible to share the 36-inch/914-mm
clearance space around each component, but there are three rules
which must always be observed:
• Space may be shared only with other Xerox equipment.
• Components may share the 36-inch/914-mm general service
clearance areas, but they may not share the 24-inch/61-mm
operator area in front of each component.
• There must be 78 inches/1981 mm of vertical clearance
throughout the entire area.
Note: Finishers attached to your bypass transport and feeders
attached to your DocuPrint 96/DocuPrint 96MX LPS through the
input enablement device may occupy shared space with Xerox
equipment. However, they must meet the Xerox DFA Level 1
specifications and be removable to allow servicing of the DocuPrint
96/DocuPrint 96MX LPS feeder/stackers. Consult with your Xerox or
Xerox Limited representatives to ensure all the requirements are
met.