Filter
Top Products
PREINSTALLATION
XEROX DOCUPRINT 96/DOCUPRINT 96MX LPS INSTALLATION PLANNING GUIDE 3-13
Tables 3-4 and 3-5 describe the turning requirements for the inverter/
feeder/stacker module.
The relatively small dimensions of the DocuPrint 96/DocuPrint 96MX
system controller and the optional peripheral cabinet are not likely to
be of concern during delivery. Refer to figures 3-1 and 3-2 for their
dimensions.
The diagrams and the tables that follow show the minimum space
needed to maneuver through a turn. To use the tables, measure the
passage or doorway width into which you wish to go at its minimum
width. This is Passage A. Find that number (or the next higher
number) on the appropriate table and read across to the
corresponding minimum value for Passage B (the passage or
doorway you are turning from).
Table 3-1. Turning radius for printer (not separated)
Passage or doorway A
width Minimum passage B width
29 inches/737 mm 83 inches/2108 mm
30 inches/762 mm 76 inches/1930 mm
31 inches/787 mm 73 inches/1854 mm
32 inches/813 mm 70.5 inches/1791
34 inches/864 mm 66.5 inches/1690 mm
36 inches/864 mm 63.5 inches/1613
38 inches/965 mm 61.5 inches/1562 mm
40 inches 1016 mm 58 inches/1473 mm
42 inches/1067 mm 55 inches/1397 mm
Table 3-2. Turning radius for printer (separated from PHM)
Passage or doorway A width Minimum passage B width
29 inches/737 mm 74.5 inches/1892 mm
30 inches/762 mm 64.5 inches/1638 mm
31 inches/787 mm 62 inches/1575 mm
32 inches/813 mm 59.5 inches/1511 mm
34 inches/864 mm 56 inches/1422 mm
36 inches/914 mm 53 inches/1346 mm
38 inches/965 mm 50 inches/1270 mm
40 inches/1016 mm 48 inches/1219 mm
42 inches/1067 mm 45.5 inches/1156 mm