Filter
Top Products
Introduction Printer Options Menu Tree Technical Info Error Messages Troublesho
Introduction 1-25
Introduction 1
Introduction Printer Options Menu Tree Technical Info Error Messages Troubleshooting
Reference Guide 8142/8160
Example A – “Overfeed” Example B – “Underfeed”
Note: When re-testing – choose the color showing the most micro-banding (e.g., the cyan sector) and test and adjust
this color only by choosing Stall Select.
To do this - press Utility Menu/Service Menu/Diagnostics Menu/Color Test Menu/Stall Select. Select the stall
(e.g., K, C, M, Y, C1, M1), then press Utility Menu/Service Menu/ Diagnostics Menu/Color Test Menu/Color
Test Print – just that color will print.
Tip: Please note that you can adjust the Paper Calibration Value while printing. This allows you to fine tune “on-
the-fly” to compensate for micro-banding.
3 Continue to adjust and print until micro-banding is gone. Then re-run the All Color Test to verify all colors are
free of micro-banding.
· If only one color now shows micro-banding check Vertical Calibration
· If banding can not be corrected and shows during normal printing, replace the cartridge.