Filter
Top Products
XES Synergix 8825/8830/8850/8855 Digital Solution User Guide 51
Special features keys (continued)
Building and printing the set
To build a collated set:
1. Press the Sets Build key. The Sets Build indicator lamp illuminates and
the SETS BUILD screen is displayed.
2. Press the Previous or the Next key to select FORWARD or REVERSE
collation.
FORWARD prints the collated set in the order that the sheets were
scanned.
REVERSE prints the set in the reverse order that they were scanned.
3. Press the Enter key to confirm your choice. The READY TO BUILD SET
screen is displayed.
4. Insert each document of the set one at a time into the Scanner as
prompted by the display. As the documents are scanned, the amount of
memory used is shown in the rectangular graphical display.
NOTE: You can select reduction/enlargement and copy quality settings for
each sheet prior to scanning that sheet.
5. When the set is completely scanned, press the Sets Build key again.
The Sets Build indicator lamp is extinguished when the Start key is
pressed then the READY TO PRINT SET screen is displayed.
6. If desired, you can now make further changes to the Media Source
selection and the Reduction/Enlargement value. Any such change will
be applied to that printing of the entire set.
7. Enter the number of copies desired and press the Start key. The Printer
prints the number of sets requested.
After the printing of the set, the set can be recalled, the values changed
again, and the set reprinted using the new values. To recall the set, refer
to "Store/Recall key" in the "Special features key" section for further
information.
SETS BUILD
COLLATION: FORWARD
READY TO BUILD SET
INSERT DOCUMENT: 1
MEMORY
100.0
AUTO
READY TO PRINT SET
PRESS START TO PRINT
100.0
3
PRINTED
1
2
3
SCANNED
1
2
3
1
2
3
SCANNED
3
2
1
PRINTED