Filter
Top Products
Using Printer Utilities
4-12 DocuPrint P1202 Reference Guide
CONFIG
Use this tab to control the following printer features:
• Power Save determines the length of time the printer waits after
a job is printed before it goes to a reduced power state. If the
printer is used frequently, select OFF which keeps the printer
ready to print with the minimum warm-up time. This uses more
electricity to keep the printer warm and ready to print.
• Econo Mode determines the toner quantity the printer should
use when printing. If set to ON, the printer conserves toner
when printing. The default value is OFF, which provides 100%
usage
• Auto Continue determines what action the printer should take
when a manual feed print job is sent to the printer and there is
no paper in the MP Tray. If set to ON, the printer will pick up
the paper from Tray 1 after ten seconds. Otherwise, the printer
will wait for you to load paper in the MP Tray.
• Altitude helps the printer optimize its output depending on the
air pressure of the region. If you are close to sea level, it should
be set to “Low.” If at a high elevation (1,500 m / 5,000 ft or
higher), set it to “High.”
• Jam Recovery determines what action the printer should take
when a paper jam occurs. When set to OFF, the printer does not
reprint a page that has jammed. When set to ON, the printer
keeps the image in memory for a printed page until the printer
signals that the page has successfully printed. The printer
reprints all jammed pages.