Filter
Top Products
Solving PostScript Problems
6-10 DocuPrint P1202 Reference Guide
Solving PostScript Problems
Table 6.3 contains problems that may occur with PostScript
printing (available only if the PostScript option is installed).
Table 6.3 PostScript Problems
Problem Possible Cause Remedy
PostScript file can not
be printed.
The PostScript option may
not be installed, or the
installed memory may be
insufficient.
Print a configuration sheet and verify that the
PS version is available for printing, and that
total system memory is at least 12 MB.
If PostScript is not available, install the
PostScript option. See “Memory and PostScript
SIMMs” (page B-4).
If system memory is not at least 12 MB, install
an 8 MB SIMM.
Error messages are
printed (i.e., “This job
contains binary data...”)
The pure binary data option
is not supported by the
PostScript driver.
Open the Properties tab of the PostScript
printer driver, click on PostScript, and click on
the Advanced button. The pure binary data
option is not supported. Choose another.
The printer name does
not appear in the
Chooser (Macintosh
only)
The LocalTalk connection is
not secure.
Make sure that the printer is powered on.
Check that the LocalTalk cable is completely
plugged into the printer and your Macintosh.
The optional Tray 2 is
not selected in the
driver.
The printer driver has not
been configured to recognize
the optional tray.
Open the PS driver Properties and set ‘Paper
Tray 2’ item of Device option to Installed.