Filter
Top Products
Windows Drivers
Xerox® Phaser® 3052/3260
User Guide
34
Networked Printer
When you connect your printer to a network, you must first configure the TCP/IP settings for the
printer. After you have assigned and veUnmarkrified the TCP/IP settings, you are ready to install the
software on each computer on the network.
1. Make sure that the printer is connected to your network and powered on.
2. Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run, and an installation window appears.
If the installation window does not appear, select Start and then Run. Type X:\Setup.exe,
replacing X with the letter which represents your drive and select OK.
If you use Windows Vista, select Start > All programs > Accessories > Run, and type X:\Setup.exe.
If the AutoPlay window appears in Windows Vista, select Run Setup.exe in Install or run program
field, and select Continue in the User Account Control window.
3. Select Install Software. A Printer Connection Type window displays.
4. Select Network connection. The Select Software to Install window displays.
5. After the installation is finished, the Setup Completed window displays.
6. After the installation is finished, select Print a test page and select Finish.
Note: For custom install instructions, refer to Custom Installation.
If your printer is connected to the computer, a Test Print page prints. If the Test Print operation is
successful, refer to the Print chapter of this guide. If the print operation failed, refer to the
Troubleshooting chapter of this guide.