Filter
Top Products
Trays
Phaser™ 4400 Laser Printer 14
g. Press the Down Arrow or Up Arrow key to scroll to the value for X, and then press the
OK key. (The X value is the measurement from the left to the right of the paper in the tray.)
h. Scroll to
Set Custom Y and press the OK key.
i. Press the Down Arrow or Up Arrow key to scroll to the value for Y, and then press the OK
key. (The Y value is the measurement from the front to the back of the paper in the tray.)
Turning off custom sizes
When you use standard size paper in the tray and adjust the guides for that paper, you don’t need to
specify the paper size in the front panel. The trays contain size sensors that automatically inform the
printer about the paper size. However, when you insert custom size paper in the tray and change
Custom Size to On, the size sensors are turned off and you must enter the X and Y values as
described in Step 4 on the previous page. If you later insert standard size paper in the tray, you must turn
on the tray sensors again by changing
Custom Size to Off:
1. On the front panel with
Menus highlighted, press the OK key.
2. Scroll to
Printer Setup Menu by pressing the Down Arrow key and press the OK key.
3. Scroll to
Tray Setup Menu and press the OK key.
4. Scroll to
Tray # Setup Menu (where # is the number of the tray) and press the OK key.
5. Scroll to
Custom Size and press the OK key to change Custom Size to Off. This
reactivates the tray sensors for that tray.