Filter
Top Products
Output Trays
Phaser™ 4400 Laser Printer 34
Offsetting output
When you send output to the 500-sheet stacker, you can also select offsetting. Offsetting separates print
jobs or collated sets of a single job by approximately 25 mm (1 in.) in the output tray.
Note
If you send output to the Standard Output Tray, the printer does not offset the output.
The 500-sheet Stacker offsets output, but you must have a hard drive to have the printer
offset collated sets.
You can switch job offsetting on or off on the front panel:
1. With
Menus highlighted, press the OK key.
2. Scroll to
Printer Setup Menu using the Up Arrow or Down Arrow key and press OK.
3. Scroll to
Job Defaults Menu and press the OK key.
4. Scroll to
Job Offset.
5. Select either
On or Off by pressing the OK key.
Note
If you change job offsetting in your printer driver, this overrides the front panel setting for
your print jobs.