Yamaha YSP-4000 Projector User Manual


 
21 En
Connections
PREPARATION
English
Cables used for connections
HDMI cable
Audio pin cable (supplied)
Optical cable (supplied)
Digital audio pin cable (supplied)
3.5 mm stereo mini plug cable
Subwoofer pin cable
OSD video pin cable (supplied) / Video pin cable
Component video pin cable
Notes on connecting the optical cable
Pull out the cap before connecting the optical cable.
When you are not using the optical cable, be sure to put the cap
back in place.
When inserting the cable into the optical digital jack, make sure
the direction is correct.
Affixing cables
To prevent cables from becoming unplugged, place the supplied cable
clamp with the open side facing upward, attach it to the rear panel of
this unit in a suitable position, and then affix cables in the cable clamp.
Information on HDMI™
Audio signals
When CPPM copy-protected DVD audio is played back, video and
audio signals may not be output depending on the type of DVD player.
This unit is not compatible with HDCP-incompatible HDMI or
DVI components.
y
We recommend that you use an HDMI cable shorter than 5 m
(16 ft) with the HDMI logo printed on it.
Use a conversion cable (HDMI jack
DVI-D jack) to connect
this unit to other DVI components.
Priority order for audio input signals
When multiple types of audio signals are simultaneously
being input from a single source component, this unit
plays back the audio signals in the following priority
order: HDMI Digital Analog
As default settings, the following input jacks are assigned
to the corresponding input sources:
Before connecting components
Audio/Video
Audio
Video
A
(White)
(Red)
(White)
(Red)
(Orange)(Orange)
5
(Yellow)(Yellow)
(Green)
(Green)
(Blue)
(Red)
(Blue)
(Red)
Cap
Input source Audio signal type
DVD video Dolby Digital, DTS, PCM
DVD audio
2-channel stereo
(up to 96 kHz/24 bit)
Blu-ray Disc
HD DVD
Dolby Digital, DTS, PCM
Notes
Input
jack
Input
Source
HDMI Digital Analog
TV/STB
DVD
AUX 1
AUX 2
AUX 3
Optical cable
Attach to this unit