Filter
Top Products
H-974
PAGE 46 OF 57
0808 IH-974
Cleaning the Cutter Module
(Cutter option required)
WARNING!!! For personnel safety, ALWAYS turn off and
unplug the printer before performing this procedure.
Refer to Figure 26.
To clean adhesive off of the upper and lower cutter blades:
1. Use a swab moistened with the Zebra-recommended solvent to wipe along the
upper cutter blade.
2. To expose the lower cutter blade, turn the cutter motor thumbnut
counterclockwise until you see the “V”-shaped lower cutter blade.
3. Clean the lower blade, following the instructions in step 1.
4. When you have finished cleaning the cutter module, plug in and turn on the
printer. The lower cutter blade will return to its correct operating positions.
If the cutter continues to perform unsatisfactorily, contact an authorized service
technician.
60 Zebra Z4M Printer User’s Guide