Filter
Top Products
H-974
PAGE 29 OF 57
0808 IH-974
Leaving the Setup Mode
You can leave the program mode at any time by pressing the SETUP/EXIT key. The
“SAVE CHANGES” display will appear. There are five choices, described below.
Pressing the INCREMENT (+) or DECREMENT (-) key displays other choices and
pressing the SELECT key selects the displayed choice.
�
PERMANENT -- Permanently saves the changes. Values are stored in the printer
even when power is turned off.
�
TEMPORARY -- Saves the changes until changed again or until power is turned
off.
�
CANCEL -- Cancels all changes since pressing the SETUP/EXIT key except the
darkness and tear-off settings (if they were changed).
�
LOAD DEFAULTS -- Loads factory defaults.
�
LOAD LAST SAVE -- Loads values from the last permanent save.
Zebra Z4M Printer User’s Guide 39
Configuration and Calibration Sequence
40 Zebra Z4M Printer User’s Guide
Display Shows Action/Explanation
PRINTER READY Normal printer operation.
Setting Print Parameters
DARKNESS
Adjusting Print Darkness Press the INCREMENT (+) key to increase darkness.
Press the DECREMENT (-) key to decrease darkness.
Default: +10
Range: 0 to +30
Darkness settings are dependent upon a variety of factors, including ribbon
type, media, and the condition of the printhead. You may adjust the darkness
for consistent high-quality printing.
If printing is too light, or if there are voids in printed areas, you should increase
the darkness. If printing is too dark, or if there is spreading or bleeding of
printed areas, you should decrease the darkness.
The FEED key self test on page 76 can also be used to determine the best
darkness setting. Since the darkness setting takes effect immediately, you can
see the results on labels that are currently printing.
CAUTION: Set the darkness to the lowest setting that provides good print
quality. Darkness set too high may cause ink smearing and/or it
may burn through the ribbon.
Darkness settings also may be changed by the driver or software settings.
TEAR OFF
Adjusting the Tear-Off Position Press the INCREMENT (+) key to increase the
value, press the DECREMENT (-) key to decrease the value. Each press of the
key adjusts the tear-off position by four dot rows.
Default: +0
Range: -120 to +120
This parameter establishes the position of the media over the tear-off/peel-off
bar after printing. The label and backing can be torn off or cut between labels.