H-974
PAGE 17 OF 57
0808 IH-974
Cutter Mode
(Cutter option required)
Refer to Figure 15.
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide out the media guide as far from the printer frame as possible.
4. Place the roll of media on the media supply hanger.
5. Flip up the media supply guide. Slide in the media supply guide so that it just
touches, but does not restrict, the edge of the roll.
6. Feed the media under the dancer, through the slot in the transmissive sensor,
under the ribbon sensor, and through the cutter module.
7. Ensure that the media is against the back of the transmissive sensor. Then, slide
in the media guide so that it just touches, but does not restrict, the edge of the
media.
8. Close the printhead assembly.
24 Zebra Z4M Printer User’s Guide
Zebra Z4M Printer User’s Guide 25
Printhead open lever
Printhead
assembly
Media supply guide
Media guide
Media
supply
hanger
Dancer
Transmissive
sensor
Ribbon
sensor
Cutter
module
Figure 15