Filter
Top Products
H-974
PAGE 38 OF 57
0808 IH-974
Zebra Z4M Printer User’s Guide 53
Display Shows Action/Explanation
IP RESOLUTION*
IP Resolution Press the INCREMENT (+) or DECREMENT (-) key to display
other choices.
Default: Dynamic
Selections: Dynamic, permanent
Depending on the selection, allows either the user (”permanent”) or the server
(”dynamic”) to select the IP address. For more information, refer to ZebraNet
Networking: PrintServer II Installation and User’s Guide.
IP PROTOCOLS*
IP Protocols Press the INCREMENT (+) or DECREMENT (-) key to display
other choices.
Default: All
Selections: All, gleaning only, RARP, BOOTP, DHCP, DHCP/BOOTP
If “dynamic” was chosen in the previous parameter, this selection determines
the method(s) by which the PrintServer II will receive the IP address from the
server. For more information, refer to ZebraNet Networking: PrintServer II
Installation and User’s Guide.
IP ADDRESS*
IP Address Press the DECREMENT (-) key to move to the next digit
position, press the INCREMENT (+) key to increase the value of the digit.
This parameter allows you to select the IP address if “permanent” was chosen
in “IP RESOLUTION.” (If “dynamic” was chosen, the user cannot select the
address.) For more information, refer to ZebraNet Networking: PrintServer II
Installation and User’s Guide.
SUBNET MASK*
Subnet Mask Press the INCREMENT (+) or DECREMENT (-) key to display
other choices.
Default: Permanent (user must set)
Selections: Dynamic (user may set, but server can assign), permanent
This parameter selects the part of the IP address that is considered to be part
of the local network. It can be reached without going through the default
gateway.
DEFAULT
GATEWAY*
Default Gateway Press the DECREMENT (-) key to move to the next digit
position, press the INCREMENT (+) key to increase the value of the digit.
This parameter allows you to select the IP address that the network traffic is
routed through if the destination address is not part of the local network.
* Option required