Filter
Top Products
H-974
PAGE 54 OF 57
0808 IH-974
Warning CUTTER JAM
OUT OF MEMORY*
Print Quality Problems
General print quality issues
Zebra Z4M Printer User’s Guide 69
Problem Solution
Cutter blade is in the media path.
Turn off the printer power and unplug the printer.
Inspect the cutter module for debris and clean as
needed following the cleaning instructions on page 60.
Problem Solution
*There is not enough memory to perform
the function shown on the second line of
the error message.
Insufficient DRAM for the label length, downloaded
fonts/graphics, and images.
Ensure that the device, such as FLASH memory or
PCMCIA card, is installed and not write protected or full.
Ensure that the data is not directed to a device that is
not installed or available.
Problem Solution
You are using an incorrect media and
ribbon combination for your application.
Consult your authorized Zebra reseller/distributor for
information and advice.
The printer is set at the incorrect print
speed.
For optimal print quality, set the print speed to the
lowest possible setting via ZPL II, the driver, or the
software.
The printer is set at the incorrect darkness
level.
For optimal print quality, set the darkness to the lowest
possible setting via the front panel, the driver, or the
software.
The printhead is dirty.
Clean the printhead according to the instructions on
page 56.
There is light printing (or no printing) on
the left or right side of the label or the
printed image is not sharp.
The pressure adjustment dials need to be adjusted.
Follow the printhead pressure adjustment instructions
on page 62.