Filter
Top Products
H-974
PAGE 18 OF 57
0808 IH-974
Value Peel-Off Mode
(Value peel option required)
Refer to Figure 16.
1. Press the printhead open lever. The printhead assembly springs up.
2. Flip down the media supply guide.
3. Slide out the media guide as far from the printer frame as possible.
4. Place the roll of media on the media supply hanger.
5. Flip up the media supply guide. Slide in the media supply guide so that it just
touches, but does not restrict, the edge of the roll.
6. Feed the media under the dancer, through the slot in the transmissive sensor, and
under the ribbon sensor.
7. Pull approximately 12” (305 mm) of media through the front of the printer.
8. Ensure that the media is against the transmissive sensor. Then, slide in the media
guide so that it just touches, but does not restrict, the edge of the roll.
9. Pull down the lever to open the pivot bracket assembly.
10. Feed the media over the tear-off/peel-off bar and behind the pivot bracket
assembly.
11. Close the printhead assembly.
12. Close the pivot bracket assembly.
13. Peeling will automatically start. Press the FEED key to test.
26 Zebra Z4M Printer User’s Guide
Zebra Z4M Printer User’s Guide 27
Media guide
Dancer
Ribbon
sensor
Label
Lever
Printhead open lever
Printhead
assembly
Media supply guide
Media
supply
hanger
Transmissive
sensor
Figure 16