Filter
Top Products
LCD Error Messages
106
57512L-004 110PAX4/R110PAX4 User Guide 6/29/11
The print engine stops.
The print engine is defragmenting
memory.
Caution • Do NOT turn off the
print engine power during
defragmenting. Doing so can damage
the print engine.
Allow the print engine to finish
defragmenting. If you get this error
message frequently, check your label
formats. Formats that write to and erase
memory frequently may cause the
printer to defragment often. Using
properly coded label formats usually
minimizes the need for defragmenting.
If this error message does not go away,
contact Technical Support. The
print engine requires service.
There is not enough memory to
perform the function specified on
the second line of the error
message.
Free up some of the print engine’s
memory by adjusting the label format
or print engine parameters. One way to
free up memory is to adjust the print
width to the actual width of the label
instead of leaving the print width set to
the default. See Set Print Width
on page 67.
Ensure that the device, such as FLASH
memory or PCMCIA card, is installed
and not write protected or full.
Ensure that the data is not directed to a
device that is not installed or is
unavailable.
Refer to the Maintenance Manual for
more information about the specified
function.
Table 9 • LCD Error Messages (Continued)
LCD Display/
Print Engine Condition
Possible Cause Recommended Solution
DEFRAGMENTING
OUT OF MEMORY
(function)