Filter
Top Products
Configuration
Control Panel Parameters
78
57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11
Set Parallel Communications
Select the communications port that matches the one being used by the host
computer.
Default: BIDIRECTIONAL
Selections: BIDIRECTIONAL, UNIDIRECTIONAL
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Serial Communications
Select the communications port that matches the one being used by the host
computer. This setting applies only when the serial port is used.
Important • Do not change this parameter from the default. The
print engine supports only RS-232. This parameter will be
eliminated in a future version of the firmware.
Default: RS232
Selections: RS232, RS422/485, RS485 MULTIDROP
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Baud
This setting applies only when the serial port is used. The baud setting of
the print engine must match the baud setting of the host computer for
accurate communications to take place. Select the value that matches the
one being used by the host computer.
Default: 9600
Selections: 110, 300, 600, 1200, 2400, 4800, 9600, 14400, 19200, 28800,
38400, 57600, 115200
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Data Bits
This setting applies only when the serial port is used. The data bits of the
print engine must match the data bits of the host computer for accurate
communications to take place. Set the data bits to match the setting being
used by the host computer.
Note • Code Page 850 requires the data bits to be set to 8 bits. See
the ZPL II Programming Guide for more information.
Default: 8BITS
Selections: 7BITS, 8BITS
To change the value shown:
1. Press the left or right oval to toggle between the options.
Table 7 • Print Engine Parameters (Page 15 of 25)
Parameter
Action/Explanation
PARALLEL COMM.
-BIDIRECTIONAL +
SERIAL COMM
-RS232 +
BAUD
-9600 +
DATA BITS
- 8 BITS