Filter
Top Products
Configuration
Control Panel Parameters
66
57512L-004 Rev. A 110PAX4/R110PAX4 User Guide 6/29/11
Select Print Mode
Print mode settings tell the print engine the method of media delivery that
you wish to use. Make sure that your print engine can support the selected
option.
Default: APPLICATOR
Selections: TEAR-OFF, REWIND, APPLICATOR
To change the value shown:
1. Press the left or right oval to scroll through the options.
Set Media Type
This parameter tells the print engine the type of media that you are using
(see Types of Media on page 35 for more information). Selecting
continuous media requires that you include a label length instruction in
your label format (
^LLxxxx if you are using ZPL or ZPL II).
When non-continuous media is selected, the print engine feeds media to
calculate label length (the distance between two recognized registration
points of the inter-label gap, webbing, or alignment notch or hole).
Default: NON-CONTINUOUS
Selections: CONTINUOUS, NON-CONTINUOUS
To change the value shown:
1. Press the left or right oval to toggle between the options.
Select Print Method
The print method parameter tells the print engine the method of printing
that you wish to use: direct thermal (no ribbon) or thermal transfer (using
thermal transfer media and ribbon).
Default: THERMAL TRANSFER
Selections: THERMAL TRANSFER, DIRECT THERMAL
Note • Selecting direct thermal when using thermal transfer media
and ribbon creates an error condition, but printing continues.
To change the value shown:
1. Press the left or right oval to toggle between the options.
Table 7 • Print Engine Parameters (Page 3 of 25)
Parameter
Action/Explanation
PRINT MODE
-APPLICATOR +
MEDIA TYPE
-NON-CONTINUOUS +
PRINT METHOD
-THERMAL-TRANS. +