Filter
Top Products
Index
23063L-003 Rev. 2 12/23/04 R110Xi/R170Xi User Guide 167
printer settings (continued)
resynch mode, 58
RFID settings, 62
RFID tag type, 63
saving, 42
sensor type, 45
serial communications, 50
setting through front panel, 42
start print signal, 57
time, 59
verifier port, 56
ZPL mode, 53
printer setup checklist, 8
printhead
cleaning, 117
early warning message, 47
head close setting, 54
head resistor value setting, 56
head test count setting, 56
pressure adjustment, 39
when to clean, 116
product improvements, 149
proprietary statement, 149
protocol setting, 51
R
R110Xi
general specifications, 143
label specifications, 146
ribbon specifications, 145
R170Xi
general specifications, 144
label specifications, 146
ribbon specifications, 145
radiation exposure limits, 150
radio frequency information, 149
read power
change through front panel, 63
change using ZPL, 93
read RFID tag
read or write RFID format (^RF), 83
read RFID tag (^RT), 91
related documents, xii
relative humidity requirements, 10
remove used ribbon, 31
replace fuse, 122
report shipping damage, 9
reset network option, 61
reship the printer, 9
resynch mode setting, 58
return data to host computer (^HV), 80
RFID
calibrate RFID tag from front panel, 63
calibrate RFID tag using ZPL (^HR), 78
change read power through front panel, 63
change read power using ZPL, 93
change write power through front panel, 63
change write power using ZPL, 93
create label formats, 69
display tag data, 64
enable motion, 85
error status, 63
guidelines, 65
LCD displays, 62
number of retries for block (^RR), 86
power settings, 68
RFID setup command (^RS), 87
RFID tag type, 63
RFID test, 62
“smart” labels, 15
transponder placement, 66
verify write operation (^WV), 97
when to perform calibration, 68
ZPL commands, 77
ribbon
adhesive test, 17
create ribbon leader, 27
determining coated side, 16
load, 26
removal, 31
RIBBON IN
message, 128
ribbon LED setting, 58
ribbon low warning, 47
Ribbon Out
message, 127
scratch test, 17
specifications, 145
troubleshooting wrinkles, 131
when to use, 16
Ribbon S. setting, 58
ribbon sensor
calibration procedure, 50
cleaning, 119
location, 119
sensitivity calibration, 36
when to clean, 116
roll media loading, 21
routine maintenance, 115
RS-232 interface connections, 104
RS-422/RS-485 interconnections, 106
RTC (Real-time clock) setting
date, 59
idle display, 59
time, 59