Filter
Top Products
Configuration
Standard Control Panel Parameters
84
79695L-003 Z Series
®
/RZ™ Series User Guide 1/11/11
Initialize Flash Memory
This option erases all previously stored information from Flash memory.
Caution • This option completely erases the Flash memory.
To initialize Flash memory:
1. Press SELECT to select the parameter.
2. If prompted for a password, enter the printer password. For instructions,
see Change Password-Protected Parameters on page 70.
The display shows
INITIALIZE FLASH?
3. Press PLUS (+) to select YES.
The display shows
ARE YOU SURE?.
4. Do you want to continue?
• Press MINUS (-) to select NO to cancel the request and return to the
INITIALIZE FLASH prompt.
• Press PLUS (+) to select YES and begin initialization.
When initialization is complete, the control panel displays
INITIALIZING MEMORY COMPLETED.
Note • Depending on the amount of free FLASH memory,
initialization may take up to 1 minute to complete.
5. Press SELECT to accept any changes and deselect the parameter.
Print Sensor Profile
A sensor profile shows sensor settings compared to actual sensor readings.
This label (which will extend across several actual labels or tags) can be
used to troubleshoot printing problems. To interpret the results of the
sensor profile, see Sensor Profile on page 137.
To print a sensor profile:
1. Press SELECT to select the parameter.
2. Press PLUS (+) to start this standard calibration procedure and print a
media sensor profile.
3. If the sensitivity of the sensors must be adjusted, perform Calibrate
Media and Ribbon Sensor Sensitivity on page 85.
4. Press SELECT to accept any changes and deselect the parameter.
Table 11 • Printer Parameters (Page 12 of 25)
Language/Parameter
Action/Explanation