Filter
Top Products
Configuration
Standard Control Panel Parameters
94
79695L-003 Z Series
®
/RZ™ Series User Guide 1/11/11
ZPL only Set Reprint Mode
When reprint mode is enabled, you can reprint the last label printed either
by issuing the ~PR ZPL command or by pressing MINUS (-) on the control
panel.
Default Value: DISABLED
Selections: ENABLED, DISABLED
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to toggle between the options.
3. Press SELECT to accept any changes and deselect the parameter.
See next column View Sensor Settings
These parameters are automatically set during the calibration procedure
and should be changed only by a qualified service technician. Refer to the
Programming Guide for ZPL, ZBI, Set-Get-Do, Mirror, and WML for
information on these parameters.
To skip these parameters:
1. Press PLUS (+) to skip each of the following parameters:
Table 11 • Printer Parameters (Page 22 of 25)
Language/Parameter
Action/Explanation