Filter
Top Products
Operations
Load Media
46
79695L-003 Z Series
®
/RZ™ Series User Guide 1/11/11
4. Feed the media under the dancer assembly (1), the upper media sensor (2), and the ribbon
sensor (
3). Slide the media back until it touches the inside back wall of the upper media
sensor.
5. Continue with the final instructions for the desired print mode. The print mode must be
compatible with the media being used and the printer options installed. See Print Mode
Descriptions and Printer Requirements on page 40 for more information.
• Additional Steps for Tear-Off Mode on page 47
• Additional Steps for Peel-Off Mode (with or without Liner Take-Up) on page 48
• Additional Steps for Cutter or Delayed Cut Mode on page 53
• Additional Steps for Rewind Mode on page 54
e. Slide in the media supply guide until
it touches the edge of the roll.
e. Slide in the media supply guide until
it touches the edge of the media.
Roll Media (Continued)
Fanfold Media (Continued)
13 2