Filter
Top Products
Zhone Technologies / 4-3
Configuring the Z-Plex Quick start system configuration
3. Change the default user password. For example:
user> SET USER:PASSWD:zplex321
The password can be from 7 to 12 characters long. The password is used any time you log
into the Z-Plex unit to manage it.
4. Configure SNMP agent addresses, community strings, and enable traps, if necessary. For
example:
user> SET CPUCFG:IPHOST1:1:192.168.10.21
user> SET CPUCFG:IPHOST2:1:192.168.10.22
user> SET CPUCFG:RDCOMSTRING:1:W23rw
user> SET CPUCFG:WTCOMSTRING:1:q34mw
5. Configure a management interface, either DS024, Ethernet, or IP over FDL. (FDL over
typically used only for a connection to a Premisys IMACs). For example, the following
commands configure a DS0 management interface:
user> SET T1CFG:DS0:1:ON
user> SET CPUCFG:MASKHDL:1:255.255.255.252
user> SET CPUCFG:IPHDL:1:192.168.8.22
6. Assign static routes if necessary. For example, the following command configures a static
host route to 62.6.5.34 with a gateway of 192.168.8.21 (the IP address of the Z-Plex
Ethernet interface):
SET ROUTE:ADDHOSTRT:10:62.6.5.34:192.168.8.21
Static routes might be necessary to telnet into the Z-Plex to manage it.
7. Set the date on the system. For example, the following commands prompt you for the
system date:
user> SET DATE
The system prompts you for the date in mm:dd:yyyy hh/mm/ss format.
8. Configure basic system contact information such as name, location, and contact.
user> SET SYSTEM:SYSCONTACT:Scott_Berman
user> SET SYSTEM:SYSNAME:ZPlex-10-2-1
user> SET SYSTEM:SYSLOCATION:10th_flr-rack_2-unit_1
9. Reboot the system:
user> REBOOT