Filter
Top Products
A-16 \ Zhone Technologies
Model No.
Running Head
Parameter reference Alphabetical Reference
NCHAN
Specifies the number of time slots onto which data from the T1 line will be mapped. Note that
starting time slots must also be selected for each data port. Channels must be contiguous.
Possible values are from 1 to 24. The default is 0.
Configuration group: DPCFG
Syntax: (GET/SET) DPCFG:NCHAN:1:(1-24)
PATTERN
The Pattern parameter specifies the test pattern for use with a BERT test on a single DS0.
Pattern applies to all time slots but you can activate the BER test on any time slot.
Possible values are:
• OFF (default):
• QRSS (quasi-random signal source): sends a QRSS pattern during the BER test.
• ALT10: sends a 10101010 pattern during the BER test.
• 2047: sends a 2047 test pattern during the BER test.
Configuration group: T1CFG
See TSBERTON, TSBERTOFF
Syntax:
(GET/SET) T1CFG:PATTERN:X:( QRSS/ALT/2047/OFF)
RATE
Rate for the data port. Each port on the V.35 port can be independently configured to operate
at speeds of 56Kbps or 64Kbps, where N equals 1 to 24.
Possible values are:
• 64K (the default): Data ports receive and transmit data at multiples of 64Kbps clear
channel. If you specify 64Kbps, you must set T1 CODE to B8ZS.
• 56K: Data ports receive and transmit data at multiples of 56Kbps clear channel.
Configuration group: DPCFG
Syntax:
(GET/SET) DPCFG:RATE:1:(56K/64K)