Filter
Top Products
Chapter 6: Using Router Setup
95
Setting Description
Specify an IP
Address
Enable this button if you are using a
static IP address and you are using 1483
protocol. Typically you have to request
and pay extra for a static IP address.
IP Address,
Subnet Mask,
Default Gateway,
and DNS
If you are using a Static IP address,
enter the values for IP Address,
Subnet Mask, Default Gateway, and
DNS server that your service provider
gave you. You must also be using the
1483 protocol.
Ethernet Filter
Type
Specifies the type of Ethernet filtering
that is performed by the bridge
interface. All-Allows all types of
Ethernet packets through the port. Ip-
Allows only IP/ARP types of Ethernet
packets through the port. PPPoE-
Allows only PPPoE types of Ethernet
packets through the port.
ATM
Traffic Class
Peak Cell Rate
Burst Tolerance
Max Cell Rate
Max Burst Rate
Sustainable Cell
Rate
These settings allow you to give priority
to data that is sent over the network.
Important! You must make
arrangements with your ADSL provider
to use anything except UBR
(Unspecified Bit Rate) in the Traffic
Class setting. Your service provider will
also supply you with the Cell, Burst, and
Tolerance Rates.