Filter
Top Products
Chapter 2: Advanced Setup Options 31
Destination
IP address of the subnet.
Netmask
Subnet mask address that corresponds to the
Destination’s IP address.
Gateway
IP address of the Gateway that is on the same
subnet as the modem.
—Specify IP
—Select Interface
Choices are enter a static IP address or select an
interface type from a dropdown list.
#
As you add entries to the Route Table, the X4
automatically assigns sequential ID numbers.
To manually configure entries for your X4’s
Route Table
, follow
these steps.
1
11
1
Enter the subnet’s IP address in the
Destination
field.
2
22
2
Enter the matching subnet mask address in the
Netmask
field.
3
33
3
Click the
Specify IP
button and enter the Gateway’s IP
address.
Tip:
If you need help determining the Gateway’s IP
address, from the Command prompt of the computer acting as
the Gateway, type
ipconfig /all
.
4
44
4
Select
Add
from the dropdown list and then click
Save
Changes
. (If you want to delete your entry and begin again,
click
Reset
.) When the
Route Table
page displays again, you
will see your new entry in the
Manually Configured Routes
table at the bottom of the page, along with an ID number.
Should you ever want to remove an individual route table entry,
follow these steps.
1
11
1
In the
Destination
and
Netmask
fields, enter the IP address
information for the entry that you want to remove. (You do
not have to enter the Gateway IP address.)
2
22
2
Select
Delete
from the dropdown list and then click
Save
Changes
.