Filter
Top Products
38 X4 ADSL Modem User’s Manual
3.4 Resetting the Unit to Its Default
Settings
If you have changed the system settings on your X4 unit and want
to restore them to the factory default settings, you can do so in one
of two ways: You can perform a software reset or a “hard” reset.
Note:
The unit’s default IP address is
http://10.0.0.2
.
If you can open your Web browser and access your X4’s user
interface, initiate a software reset:
•
From the
Advanced Setup
page, under
Administration
, click
Reset to Default
. You will be prompted to click the
Write
Settings to Flash and Reboot
button. Once this process is
complete, your unit is reset to its factory settings. Click on any
of the icons at the top of page to continue.
If you lose your link to the unit and cannot communicate with it
via the Web browser, initiate a hard reset.
•
Using a paper clip, press the
RESET
button on the unit’s back
panel. While holding in this button, count to five, and then
release the button. The unit’s
LINK
light will turn off and
then it will blink slowly, about once per second. You are now
guaranteed that all system settings are set to the unit’s factory
defaults.