Filter
Top Products
AES-100 User’s Guide
System Commands 4-5
192.168.1.1 sys> secured host add <host IP>
where
<host IP> =
IP address of a secured host.
This command adds the IP address of a secured host. You may add up to ten IP addresses.
4.6.3 Secured Host Delete Command
Syntax:
192.168.1.1 sys> secured host delete <host IP>
where
<host IP> =
IP address of a secured host.
This command deletes the IP address of a previously added secured host.
4.7 UNIX Syslog Commands
Use UNIX syslog commands to send logs to your UNIX syslog server. If the ADSL link is on or goes down, the
AES-100 will send a log to your UNIX syslog server. The table, shown next, indicates what is logged in each case.
Table 4-1 Logs Sent to Your UNIX Server
ADSL LINK ON ADSL LINK DOWN
port number port number
sequence number sequence number
rate -
If your Unix syslog server is down these logs will be lost.
4.7.1 Syslog Command
Syntax:
192.168.1.1 sys> syslog [<mode>]
where
<mode> =
enable or disable.
This command enables or disables the sending of logs to your Unix syslog server. The default is disable (<mode>=
disable). A log is sent if <mode>= enable. To display current settings, do not specify a <mode>.
4.7.2 Syslog Facility Command
Syntax:
192.168.1.1 sys> syslog facility <facility>
where
<facility> =
local1 to local7.