Filter
Top Products
AES-100 User’s Guide
4-6 System Commands
This command sets the syslog facility for the UNIX system.
4.7.3 Syslog Server Command
Syntax:
192.168.1.1 sys> syslog server <server IP>
where
<server IP> =
IP address of syslog server.
This command sets the UNIX syslog server IP address. If <server IP>=0.0.0.0 (default), then logs will be
dropped (not be sent).
4.8 System Error Log Commands
The system error log will record error events locally to the AES-100 memory. You may clear or display these logs
using the commands listed in this section.
The following lists what logs the system error log can record.
• ADSL link on (port number, sequence number,
rate, noise margin, attenuation)
• ADSL link down (port number, sequence
number, noise margin, attenuation)
• ADSL OVER_HEAT_ACTIVE (temperature) • ADSL OVER_HEAT_RELEASE (temperature)
• Console session begin • Console session end
• Telnet session begin • Telnet session end
• Incorrect telnet password • Insecure telnet access (IP address)
• FTP session begin • FTP session end
• Incorrect FTP password • Insecure FTP access (IP address)
• FTP image error (reason) • FTP receive file OK (file name)
• System reboot
4.8.1 Errlog Display Command
Syntax:
192.168.1.1 sys> errlog display
This command displays the system error log.
4.8.2 Errlog Clear Command
Syntax:
192.168.1.1 sys> errlog clear
This command clears the system error log.
If you clear a log (using the errlog clear command), you may not view it again.