Filter
Top Products
AES-100 User’s Guide
8-6 IEEE 802.1QTagged VLAN Commands
The switch sees that port #s 2, 3, 4, 6, 8 and 9 (ADSL ports 1, 2, 3, 5, 7 and 9) are all set to “fixed” and “untag”
which means the SVLAN allows the frame to be sent to those ports without a tag.
Port # 5 is “forbidden” so the frame is not forwarded to adsl port # 4.
Port # 7 (ADSL port 6) is “normal” which means that it was entered dynamically, so the frame is permitted to be
forwarded to port # 7 if port # 7 is registered in the DVLAN table.
After looking at the SVLAN, the switch sees that the port filter is set for port 1 (the LAN port) to forward frames to
all of the ADSL ports, so the switch forwards everything that the SVLAN permits.
Please note that the switch also sends the frame to “CPU” (the switch itself), because the switch is a member of this
VLAN. The switch can be a member of only one VLAN at a time.
8.5.7 SVLAN Getentry Command
Syntax:
192.168.1.1 vlan1q> svlan getentry <vid>
where
<vid> =
VLAN ID. Valid parameter range = [1 – 4094].
This command displays an entry with a specified VLAN ID in the static VLAN table.
Display a Static VLAN Table Entry Example
The following figure is an example display of the following command.
192.168.1.1 vlan1q> svlan getentry 2
Figure 8-5 Example: Svlan Getentry 2 Command Display
8.5.8 SVLAN Delentry Command
Syntax:
192.168.1.1 vlan mgr> svlan delentry <vid>
where
<vid> =
VLAN ID. Valid parameter range = [1 – 4094].
This command deletes an entry with a specified VLAN ID in the static VLAN table
Delete a Static VLAN Entry Example
The following example will delete entry 2 in the static VLAN table.
192.168.1.1 vlan mgr> svlan delentry 2
vid port# ad_control tag_control
-------- ------- ------------ ------------
2 1 normal UnTag
2 fixed UnTag
3 normal UnTag