Filter
Top Products
ES-2108/ES-2108-G User’s Guide
120 Chapter 22 Access Control
Figure 69 Access Control: SNMP
The following table describes the labels in this screen.
22.4 Setting Up Login Accounts
Up to five people (one administrator and four non-administrators) may access the switch via
web configurator at any one time.
• An administrator is someone who can both view and configure switch changes. The
username for the Administrator is always admin. The default administrator password is
1234.
Note: It is highly recommended that you change the default administrator password
(1234).
• A non-administrator (username is something other than admin) is someone who can
view but not configure switch settings.
Click Access Control from the navigation panel and then click Logins from this screen.
Table 45 Access Control: SNMP
LABEL DESCRIPTION
Get Community Enter the get community, which is the password for the incoming Get- and GetNext-
requests from the management station.
Set Community Enter the set community, which is the password for incoming Set- requests from the
management station.
Trap Community Enter the trap community, which is the password sent with each trap to the SNMP
manager.
Trap Destination Enter the IP addresses of up to four stations to send your SNMP traps to.
Apply Click Apply to save your changes back to the switch.
Cancel Click Cancel to begin configuring this screen afresh.