Filter
Top Products
ES-2108/ES-2108-G User’s Guide
162 Chapter 27 Introducing the Commands
27.9.5 config-vlan Commands
The following table lists the vlan commands in configuration mode.
pvid <1-4094>
The default PVID is VLAN 1 for
all ports. Sets a PVID in the
range 1 to 4094 for the specified
interface.
qos priority <0 .. 7>
Sets the quality of service
priority for an interface.
speed-duplex <auto|10-half|10-
full|100-half|100-
full|1000-full>
Sets the duplex mode (half or
full) and speed (10, 100 or
1000 Mbps) of the connection
on the interface. Selecting
auto (auto-negotiation) makes
one port able to negotiate with a
peer automatically to obtain the
connection speed and duplex
mode that both ends support.
test
Performs an interface loopback
test.
vlan-trunking
Enables VLAN Trunking on
ports connected to other
switches or routers (but not
ports directly connected to end
users) to allow frames
belonging to unknown VLAN
groups to pass through the
switch.
Table 59 interface port-channel Commands (continued)
COMMAND DESCRIPTION
Table 60 Command Summary: config-vlan Commands
COMMAND DESCRIPTION
vlan <1-4094>
Creates a new VLAN group.
exit
Leaves the VLAN configuration mode.
fixed <port-list>
Specifies the port(s) to be a permanent
member of this VLAN group.
forbidden <port-
list>
Specifies the port(s) you want to
prohibit from joining this VLAN group.
help
Displays a list of available VLAN
commands.
inactive
Disables the specified VLAN.
ip address <ip-address>
<mask>
Sets the IP address and subnet mask
of the switch in the specified VLAN.
<ip-address>
<mask>
[manageable]
Sets the management IP address and
subnet mask of the switch in the
specified VLAN.