Filter
Top Products
ES-2108/ES-2108-G User’s Guide
148 Chapter 27 Introducing the Commands
Figure 96 CLI Help: Detailed Command Information: Example 1
Figure 97 CLI: Help: Detailed Command Information: Example 2
27.6 Command Modes
There are three CLI command modes: User, Enable and Configure.
When you first log into the CLI, the initial command mode is the User mode. The User mode
commands are a subset of the Enable mode commands. The User mode command prompt ends
with an angle bracket (>).
To enter Enable (or privileged) mode, type
enable and enter a password when prompted (the
default is 1234). When you enter the Enable mode, the command prompt changes to the pound
sign (
#).
To enter the configuration mode, type
configure or config. The Configure mode command
prompt consists of the word “
config” and the pound sign (#). There are various sub
configuration modes: interface, router and VLAN.
• To enter config-vlan mode, type
vlan followed by a number (between 1 to 4094). For
example,
vlan 10 to configure settings for VLAN 10.
• To enter config-interface mode and configure the ports, enter
interface port-
channel
followed by a port number. For example, interface port-channel 8.
Enter
exit or logout to quit from the current mode or log out from the CLI.
ras> ping help
Commands available:
ping <ip>
<
[ vlan <vlan-id> ]
[ size <0-1472> ]
[ -t ]
>
ras>
ras> ping ?
<ip> destination ip address
help Description of ping help