Filter
Top Products
ES-2108/ES-2108-G User’s Guide
Chapter 28 Command Examples 175
Figure 117 wrr Command Example
28.10 interface Commands
These are some commonly used commands that belong to the interface group of
commands.
28.10.1 interface port-channel
Syntax:
interface port-channel <port-list>
Use this command to enable the specified ports for configuration. Type multiple ports or port
ranges separated by a comma. Ranges of port numbers are typed separated by a dash.
An example is shown next.
• Enter the configuration mode.
• Enable ports one, three, four and five for configuration.
• Begin configuring for those ports.
Figure 118 interface Command Example
28.10.2 bmstorm-limit
Syntax:
bmstorm-limit
bmstorm-limit <Kbps>
where
ras# configure
ras(config)# wrr
ras(config)# wrr 4 3 2 1
ras# config
ras(config)# interface port-channel 1,3-5
ras(config-interface)#
Enables broadcast storm control limit on the switch.
<Kbps>
Limits broadcast packet traffic the interface receives per second.