Filter
Top Products
Dimension ES-4024 Ethernet Switch
Introduction to CLI 35-5
Table 35-1 CLI Command Summary: sys
COMMAND DESCRIPTION
switch [on|off]
Turns the watchdog firmware
protection feature on or off.
cnt [value]
Sets (0-34463) or displays the
current watchdog count (in 1.6 sec
units).
monitor status
Displays the status of the hardware
monitor.
show
Displays the hardware monitor’s
statistics.
vlimit <idx> <high> <low>
Sets the maximum (<high>) or
minimum (<low>) voltage at the
specified point (<idx>).
tlimit <idx> <limit>
Sets the maximum (<limit>)
temperature at the specified point
(<idx>).
flimit <bank> <idx> [<limit>]
Sets the maximum (<limit>) fan
revs per minute (RPM) at the
specified fan (<idx>) in the
specified bank (<bank>). A “bank”
delineates a set of fans.
fanmask <bank> [<mask>]
Sets the fan detection mask in the
specified bank (<bank>). Use the
mask to disable monitoring of a
fan.
vclear
Clears the voltage statistics.
tclear
Clears the temperature statistics.
fclear
Clears the fan statistics.
clear
Clears the hardware monitor
statistics.
enable [<on/off>]
Enables or disables the hardware
monitor.
test
Tests the hardware monitor chip.
ixe2424 lbt intlbt <port|All> [count]
ixe2424 refers to the switch chip.
Performs an internal loop back test
on a specified port or all ports.
lbt extlbt <port> [count]
Performs an external loop back
test on a specified port or all ports.
pktcnt <port 1-28>
Displays port statistic counter
pktcntclear <port 1-28>
Resets port statistic counter
port <portID> <enable | disable>
<Speed> <FlowCtrl>
Port setup
phyread <portID> [<phyAddr>]
Reads PHY register