Filter
Top Products
Dimension ES-4024 Ethernet Switch
6-6 Basic Setting
The following table describes the labels in this screen.
Table 6-3 Basic Setting: Switch Setup
LABEL DESCRIPTION EXAMPLE
VLAN Type Choose 802.1Q or Port Based. The VLAN Setup screen changes depending on
whether you choose 802.1Q VLAN type or Port Based VLAN type in this screen.
See Section 6.4 and the chapter on VLAN for more information.
802.1Q
IGMP
Snooping
Select the Active checkbox to enable IGMP snooping have group multicast traffic
only forwarded to ports that are members significantly reducing multicast traffic
passing through your switch. See Section 6.5 for more information on IGMP
snooping.
You cannot enable both IGMP snooping and IGMP at the same time.
Refer to the section on IGMP for more information.
MAC Address
Learning
MAC address learning reduces outgoing traffic broadcasts. For MAC address
learning to occur on a port, the port must be active.
Aging Time Enter a time from 10 to 3000 seconds. This is how long all dynamically learned
MAC addresses remain in the MAC address table before they age out (and must
be relearned).
300
GARP Timer: Switches join VLANs by making a declaration. A declaration is made by issuing a Join message
using GARP. Declarations are withdrawn by issuing a Leave message. A Leave All message terminates all
registrations. GARP timers set declaration timeout values. See the chapter on VLAN setup for more background
information.
Join Timer Join Timer sets the duration of the Join Period timer for GVRP in milliseconds.
Each port has a Join Period timer. The allowed Join Time range is between 100
and 65535 milliseconds; the default is 200 milliseconds. See the chapter on
VLAN setup for more background information.
200 milliseconds
(default)
Leave Timer Leave Timer sets the duration of the Leave Period timer for GVRP in
milliseconds. Each port has a single Leave Period timer. Leave Time must be two
times larger than Join Timer; the default is 600 milliseconds.
600 milliseconds
(default)
Leave All
Timer
Leave All Timer sets the duration of the Leave All Period timer for GVRP in
milliseconds. Each port has a single Leave All Period timer. Leave All Timer must
be larger than Leave Timer; the default is 1000 milliseconds.
1000
milliseconds
(default)
Priority Queue Assignment
IEEE 802.1p defines up to 8 separate traffic types by inserting a tag into a MAC-layer frame that contains bits to
define class of service. Frames without an explicit priority tag are given the default priority of the ingress port. Use
the next two fields to configure the priority level-to-physical queue mapping.
The switch has 4 physical queues that you can map to the 8 priority levels. On the switch, traffic assigned to higher
index queues gets through faster while traffic in lower index queues is dropped if the network is congested.
Priority Level (The following descriptions are based on the traffic types defined in the IEEE 802.1d standard (which
incorporates the 802.1p).
Level 7 Typically used for network control traffic such as router configuration messages.
Level 6 Typically used for voice traffic that is especially sensitive to jitter (jitter is the variations in delay).