Filter
Top Products
Dimension ES-4024 Ethernet Switch
Introduction to CLI 35-13
Table 35-2 Command Summary: sys sw
COMMAND DESCRIPTION
applyidx <Class Idx>
<MirrorType=input|output|both>
Applies class to mirroring.
del <Class Idx>
Deletes a mirroring class.
disable
Clears current run-time port
mirror settings.
display [class idx]
Displays current run-time port
mirror settings.
set <src port> <src MAC> <src vid>
<dest port> <dest MAC> <dest vid>
Creates a mirror rule using
source/destination port, MAC
address and VLAN group
information. “*” means “any”.
<input|output|both>
Sets the direction of mirrored
traffic.
port <port>
Sets the mirror port (the port
traffic is copied to for analysis).
bw
The following commands relate to
bandwidth control rules.
Bandwidth control means defining
a maximum allowable bandwidth
for traffic flows from specified
source(s) to specified
destination(s).
applyidx <Class Idx> <Max BW>
Apply class to bandwidth control.
del <Class Idx>
Delete a bandwidth control class.
disable
Clears current run-time bandwidth
control rules.
display
Displays current run-time
bandwidth control rules.
set <src port><src mac><src vid><dest
port><dest mac><dest vid><max bw>
Creates a bandwidth control rule
using source/destination port,
MAC address and VLAN group
information. “*” means “any”.
trunk
The following commands relate to
trunking. Trunking is the grouping
of physical ports into one logical
higher-capacity link.
del <id>
Deletes a trunk group.
disable
Clears current run-time trunk
settings.
display
Displays current run-time trunk
settings.
listView
Displays member list of trunk.
set <group><# ports>
Adds ports to a trunk group.