ZyXEL Communications GS-4024 Switch User Manual


 
Chapter 45 Introducing Commands
GS-4012F/4024 User’s Guide
369
egress <Kbps> Sets the maximum bandwidth
allowed for outgoing traffic on the
port(s).
13
bpdu-control
<peer|tunnel|disc
ard|network>
Sets how Bridge Protocol Data
Units (BPDUs) are used in STP
port states.
13
broadcast-limit Enables broadcast storm control
limit on the port(s).
13
<pkt/s> Specifies the maximum number of
broadcast packets to allow
through the port.
13
dhcp snooping
trust
Sets this port as a trusted DHCP
snooping port. Trusted ports are
connected to DHCP servers or
other switches, and the Switch
discards DHCP packets from
trusted ports only if the rate at
which DHCP packets arrive is too
high.
13
dhcp snooping
limit rate <pps>
Sets the maximum rate that
DHCP packets are allowed to
arrive at a trusted DHCP snooping
port.
13
diffserv Enables DiffServ on the port(s). 13
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
13
<pkt/s> Sets the interface DLF limit in
packets per second (pps).
13
egress set <port-
list>
Sets the outgoing traffic port list
for a port-based VLAN.
13
ethernet oam Enables Ethernet OAM on the
port(s).
13
mode
<active|passive>
Specifies active or passive OAM
mode on the ports. Active mode
allows the port to issue remote
loopback and discovery
commands. Passive mode means
that the port can only respond to
Ethernet OAM commands.
13
remote-loopback
supported
Enable Ethernet OAM remote-
loopback capability on the port(s).
13
exit Exits from the interface port-
channel command mode.
13
flow-control Enables interface flow control.
Flow control regulates
transmissions to match the
bandwidth of the receiving port.
13
frame-type
<all|tagged|untag
ged>
Choose to accept both tagged
and untagged incoming frames,
just tagged incoming frames or
just untagged incoming frames on
a port.
13
Table 140 interface port-channel Commands (continued)
COMMAND DESCRIPTION PRIVILEGE