Filter
Top Products
GS-4012F/4024 User’s Guide
383
CHAPTER 47
Configuration Mode Commands
This chapter describes how to enable and configure your Switch’s features using commands.
For more background information, see the feature specific chapters which proceed the
commands chapters.
47.1 Change the Out of Band Management IP Address
Use the ip address command to change the IP address of the out of band management port
on the Switch.
Syntax:
ip address <IP Adress> <Subnet Mask>
An example is shown next.
• Change the out of band Management IP address to 192.168.0.2
• View updated settings.
See example in Section 48.2 on page 395 for information on how to change the in band
management IP address for the Switch.
47.2 Enabling IGMP Snooping
To enable IGMP snooping on the Switch. Enter igmp-snooping and press [ENTER]. You
can also set how to treat traffic from an unknown multicast group by typing the
unknown-
multicast-frame
parameter.
sysname(config)# ip address 192.168.0.2 255.255.255.0
sysname(config)# exit
sysname# show ip
Management IP Address
IP[192.168.0.2], Netmask[255.255.255.0], VID[0]
IP Interface
IP[192.168.2.1], Netmask[255.255.255.0], VID[2]