ZyXEL Communications GS-4024 Switch User Manual


 
Chapter 46 User and Enable Mode Commands
GS-4012F/4024 User’s Guide
378
46.2.2 show ip
Syntax:
show ip
This command displays the IP related information (such as IP address and subnet mask) on all
Switch interfaces.
The following figure shows the default interface settings.
46.2.3 show logging
Syntax:
show logging
This command displays the system logs. The following figure shows an example.
" If you clear a log (by entering y at the Clear Error Log (y/n):prompt), you
cannot view it again.
46.2.4 show interface
Syntax:
show interface [port-number]
sysname> show ip
Management IP Address
IP[192.168.0.1], Netmask[255.255.255.0], VID[0]
IP Interface
IP[192.168.1.1], Netmask[255.255.255.0], VID[1]
sysname>
sysname# show logging
1 Thu Jan 1 00:02:08 1970 PP05 -WARN SNMP TRAP 3: link up
2 Thu Jan 1 00:03:14 1970 INFO adjtime task pause 1 day
3 Thu Jan 1 00:03:16 1970 PP0f -WARN SNMP TRAP 26: Event On Trap
4 Thu Jan 1 00:03:16 1970 PINI -WARN SNMP TRAP 1: warm start
5 Thu Jan 1 00:03:16 1970 PINI -WARN SNMP TRAP 3: link up
6 Thu Jan 1 00:03:16 1970 PINI INFO main: init completed
7 Thu Jan 1 00:00:13 1970 PP26 INFO adjtime task pause 1 day
8 Thu Jan 1 00:00:14 1970 PP0f -WARN SNMP TRAP 26: Event On Trap
9 Thu Jan 1 00:00:14 1970 PINI -WARN SNMP TRAP 0: cold start
10 Thu Jan 1 00:00:14 1970 PINI INFO main: init completed
11 Thu Jan 1 00:00:04 1970 PP05 -WARN SNMP TRAP 3: link up
11 Thu Jan 1 00:00:04 1970 PP05 -WARN SNMP TRAP 3: link up
Clear Error Log (y/n):